![]() The second run was using the Advance setting where I rebuild the boot sector which I did based on a few posts here in the forum. The first run is similar to the one I described in this post, which I ended since I didn't know what to do. This is my 3rd run of testdisk and I have gone nowhere. I've attached screenshots and the log file of my testdisk run. I did not attempt a deep search yet as I know that takes a loooooong time and I don't want to try it until I know that there's nothing else wrong with my disk. I tried searching for a reason for this but could not find any with similar experiences (that or I am bad at searching the web or have an incredibly low iq). However, what's different is that the file names of the files that testdisk found are unreadable (e.g. ![]() After anaylsing (quick search) the disk, I could see that it found some files. I followed the steps on how to use test disk but I have come to a part that deviates from the expected behavior. I just restarted my pc, unplugged and plugged the HDD bay, and changed the disk's position in the hdd bay but it did not change its RAW status (I know this wouldn't work I was just being optimistic that all it needed was a few nudges here and there). After plugging it in, my Win7 PC could detect the drive, albeit in a RAW partition with the usual prompts of 'Do you want to format the drive?'. Having no alternative and thinking it might be the drive's case/interface that's causing the problem, I opened it and placed it in an HDD bay. I don't have a linux computer so I couldn't test it there. I tried plugging it in an old Windows XP laptop and it could not be detected. It just wasn't showing up in the drive list. I did nothing to it I did not move it, I did not unplug it, nothing. Recently, the drive could not be detected by my computer (Windows 7 32-bit). It has always been very slow to load before whenever I open it in Windows explorer, the drive would take about 5 minutes to load before I can explore it's contents but it wasn't something I could not deal with. ![]() change file system, format, partitioned). ![]() As far as I can remember, I used it right out of the box without anything done to it (e.g. I have a WD My Book Essential 2TB that I store my media in (i.e. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |